Home > SI Documentation (v14) > Knowledge Base > Visio/AutoCAD not Linked to SI

Visio/AutoCAD not Linked to SI




You open a Visio or AutoCAD file in SI and none of the "SI" stuff loads, e.g. no Project Editor or D-Tools SI Shapes window open.



This is likely due to Visio or AutoCAD having been installed after the SI Client was installed, so our Add-Ins for these could not be loaded.


To fix, open SI and then got to Start->Setup->Control Panel:


4-7-2016 2-50-12 PM.png


Under the Drawing Add-Ins Manager section, run the appropriate function for your Visio, either 32-bit or 64-bit. In most cases, Visio will be installed as 32-bit.


add ins manager buttons.png


When you run this file it will open the following interface:


addins manager form.png


You will get a confirmation message:



Contact Support


If you cannot resolve this issue, please open a Support Ticket.

Last modified



This page has no classifications.