Home > SI 2015 Documentation > User Guide > Reports > Standard Reports > Wire Connections

Wire Connections

SI_2015_logoset-1 - small.png

Details

 

This page describes the Wire Connections report. This report is dependent on wire connections in Visio and AutoCAD, generally on a Schematic page. There is a one report that will allow you to group via the Report Definitions, and two others that are coded to group "By From Item" and "By To Item".

Definitions

 

This report has the following default Report Definitions:

 

reports in list.png

Layout and Fields

 

In this example the Wire Connections report was run "By Wire Number":

 

body.jpg

 

Displayed at the top of report is your company name and phone number, Project information, report name, Modified, and Revision fields.

Body

 

The fields that display for each grouping are as follows: OK (check box), From Device (Manufacturer-Model and Component ID), From Connection (Output Terminal-Label) , Wire (Manufacturer-Model), Wire (Component ID).

Page Footer

 

page footer.jpg

 

The footer lists your company name and the page number.

 

Another example shown below is of the Wire Connection (By From Item) report. Notice that it groups on the device where the wire originates:

 

wire connections by from device.png

Wire Connections

 

This report relies on wire connections in Visio and/or AutoCAD and is intended to report off of Schematic drawings.

 

schematic example.jpg

 

connection example.jpg

Tips

 

This is a good report to use the "Drawing Pages" Options on the Reports tab with the Project Editor within the Visio interface:

 

report options.jpg

Last modified

Tags

This page has no custom tags.

Classifications

This page has no classifications.