Share |
Table of contents
  1. 1. Reporting Interface

Reporting Interface

The Reports tab allows you to run reports for the selected project.  For additional information about reports see this section of the D-Tools Blog: http://www.d-toolsblog.com/si-reports/

File:Reports/image001.jpg

note_50You can also run reports from within an open Project by selecting D-Tools->Reports from the menu bar:

File:Reports/image003.png

Although not shown, you can do this from within the Visio and AutoCAD project interfaces as well.

If you were also a V4.6 user and have SI 5 loaded on the same machine where SI 4 is installed, you may access your legacy reports from within an open project by selecting D-Tools-> Reports, then select File-> Legacy Reporting System as shown below.

File:Reports/image004.png

A familiar form will open. While we hope this is comforting to you, you must abandon these archaic reports and embrace the new SI 5 reports at some point, the sooner the better…seriously.

File:Reports/image005.jpg

See the SI4 Users Guide for more details on how to use this interface.

The Reports interface has a Projects sub-tab that lists all of your projects in your current "Show" Selection.  There is a Toolbar with buttons that will be described below.  The Navigator Bar displays a list of all of your Reports.

reports tab.jpg


 For more information:

Tag page

Files 1

FileSizeDateAttached by 
 Document2
No description
632.37 kB04:57, 16 Jan 2010Adam StoneActions
Share |


comments powered by Disqus
Please note that all comments are moderated so it could take some time before they show up.