Home > SI 2016 Documentation > User Guide > Reports > Standard Reports > Wire Connections

Wire Connections

SI_2015_logoset-1 - small.png



This page describes the Wire Connections report. This report is dependent on wire connections in Visio and AutoCAD, generally on a Schematic page. There is a one report that will allow you to group via the Report Definitions, and two others that are coded to group "By From Item" and "By To Item".



This report has the following default Report Definitions:


Layout and Fields


In this example the Wire Connections report was run "By Wire Number":




Displayed at the top of report is your company name and phone number, Project information, report name, Modified, and Revision fields.



The fields that display for each grouping are as follows: OK (check box), From Device (Manufacturer-Model and Component ID), From Connection (Output Terminal-Label) , Wire (Manufacturer-Model), Wire (Component ID).

Page Footer


page footer.jpg


The footer lists your company name and the page number.


Another example shown below is of the Wire Connection (By From Item) report. Notice that it groups on the device where the wire originates:


wire connections by from device.png

Wire Connections


This report relies on wire connections in Visio and/or AutoCAD and is intended to report off of Schematic drawings.


schematic example.jpg


connection example.jpg



This is a good report to use the "Drawing Pages" Options on the Reports tab with the Project Editor within the Visio interface:


report options.jpg

Last modified


This page has no custom tags.


This page has no classifications.